How to deal with the optical fiber laser cutting machine intermittent there is light

Among for the use of laser cutting machine equipment, intermittent light of this problem, the probability is very low, but also is happening, for advanced optical fiber laser cutting machine equipment, however, when this type of problem, what should the operation is correct? What factors lead to intermittent light?

1, laser power supply voltage instability is easy to cause intermittent light optical fiber laser cutting machine equipment, for the solution of this kind of parts, is to use a voltage stabilizer to stabilize voltage, so as to make the output voltage constant values.
2 dust or damage is found, lens, lead to serious deviation of optical path can also cause this type of problems and then a clean-up shall be given to the optical lens, and then to adjust the light path.
3, optical fiber laser cutting machine equipment caused by the abnormal of water cycle and water protection, when the water type problem is not normal, need to feed water pump and the pipe to a clean, prevent there were sundry jam.
4, the most direct problem, and that is the whole piece of optical fiber laser cutting machine equipment, the service life of laser tube, due to there is intermittent light problem, so the method to solve the problem of this kind of change of laser tube.

Leave a Reply

Your email address will not be published. Required fields are marked *