CO2 laser cutting machine Cautions

CO2 laser cutting machine Cautions

1,. laser tube laser cutting machine to be reasonable in the installation fulcrum fulcrum should be 1/4 of the total length co2 laser cutting machine of the laser tube, or cause deterioration of the laser tube spot mode, thus affecting the normal operation of laser cutting machine, and some work for some time spot into a few points, resulting in decreased laser power can not meet the requirements, resulting in constantly changing tubes, carefully read the “Note the use of the laser tube.”

2. The cooling system to be grounded, regular cleaning of water tanks and water, cooling water tank thermostat temperature control point to be reasonable, otherwise the laser tube is easily damaged and cause condensation power down, cold water header pipe off, life is shortened, and sometimes does not work, resulting in constantly changing tubes.

3, water protection should always check the cleaning, cooling water is often not red water protection water protection float switch or float switch is not reset, the method can not be used to solve the pressing short. Cooling water quality is better, faucets aluminum oxide is too serious a period of time should be regularly cleaned using pumps and pipes,  metal laser cutting machine  water protection in the dirt, or cause pipes to burst or cold laser head off, it will seriously affect the normal use of laser cutting machine .

The ATC wood cnc router with independent knife library, it can change required tools automatically during working without stop. The atc 3d engravingmachine is most suitable for engraving intricate patterns, with higher speedand higher efficiency.

This wood machine can do both cutting and 3D engraving works.
4, the suction device should be checked regularly to clean, clean the fan duct. Otherwise, do not go out a lot of smoke dust discharge, severe pollution fast lens and laser tube, so that all mechanical and electronic components susceptible to oxidation caused by bad contact.

5, focusing mirror and mirror checks, work for a frame on the heat, the lens surface rust discoloration; Tuomo cracking belong to the object to be replaced, especially a lot of customers with a large air pump and air Laser engraver for sale compressor, so the focus of the lens the water quickly, so you must check the cleanliness and quality is good or bad time lens (laser tube light mouth) optical system.

6, the machine can not be too harsh working environment, if the ambient temperature is above 30 degrees, 18 degrees lower than the next, too much dust, air pollution is serious, so serious damage to the machine, the failure rate is rising;

The humid environment of each electrical accessories easily problems. So in this special alert customers to improve working conditions and regular maintenance of the machine.

7, the power to match the electricity grid. Each part of the power distribution and the contact point of the whole equipment to be good (fan, water-cooled machines, laser machines, laser power supply, computer power supply to be independent).

8, the laser tube operating current to be reasonable, not long-term work in light intensity 90-100; to rationalize the application of laser and laser energy conservation; optical system to be cleaned properly,  co2 laser engraving machine otherwise cause premature aging and cracking laser tube, so the laser machine working time strong should be adjusted at 50-60%, depending on the material and then to adjust the working speed, so that the laser tube is the best working condition.

9, the base plate and the material to be machined smooth, otherwise the focal length of the cut is inconsistent in some places do not wear, so it is imperative to increase the light intensity will cause rapid aging of the laser tube.

Jinan MORN Technology Co.,Ltd is located in the high-tech development zone in Jinan city, north of China. Our company is the professional manufacturer and exporter of mechanical CNC router machine, laser machine and other relevant equipment.

MORNTECH-CHINA(FACTORY)
Phone: +0086 531 66982237
Fax: +0086 531 88692337
Email: info@morntech.com
Add:High-tech development zone,Jinan city
Our cnc router website:www.morntech.com

Leave a Reply

Your email address will not be published. Required fields are marked *